¶ Rear Toe
Rear toe is identified by the C and D plate numbers marked on the part as shown below.
 |
|---|
| Stock C and D plate - 3 degrees |
To determine the toe angle for 2 specific plates; the difference in number (between D and C blocks) must be halved.
The matrix below shows the combinations possible:
 |
|---|
| Rear toe angles possible on MX8. Yellow = stock. Grey = recommended options |
¶ Part Numbers
Mayako uses screw type hingepins front and rear for added durability (from 2023). This C and D blocks as below:
| Part Number | Description | Measurement |
|---|---|---|
| MYB0029A | C-Block (Screw Type Inner Hinge Pin), use with MYB0030A for 3deg | 48.5mm |
| MYB0029-01A | C-Block Wide (Screw Type Inner Hinge Pin), use with MYB0030-01A for 1.5deg | 50mm |
| MYB0029-02A | C-Block Wide (Screw Type Inner Hinge Pin), use with MYB0030-02A for 0.5deg | 51mm |
| MYB0030A | D-Block (Screw Type Inner Hinge Pin), use with MYB0029A for 3deg | 54.5mm |
| MYB0030-01A | D-Block(Screw Type Inner Hinge Pin), use with MYB0029-01A for 1.5deg | 53mm |
| MYB0030-02A | D-Block (Screw Type Inner Hinge Pin), use with MYB0029-02A for 0.5deg | 52mm |
¶ Previous iterations
Prior to 2023, non screw type hingepins were used with the block below:
| Part Number | Description | Measurement |
|---|---|---|
| MYB0029 | C-Block, use with MYB0030 for 3deg | 48.5mm |
| MYB0029-01 | C-Block Wide, use with MYB0030-01 for 1.5deg | 50mm |
| MYB0029-02 | C-Block Wide, use with MYB0030-02 for 0.5deg | 51mm |
| MYB0030 | D-Block, use with MYB0029 for 3deg | 54.5mm |
| MYB0030-01 | D-Block, use with MYB0029-01 for 1.5deg | 53mm |
| MYB0030-02 | D-Block, use with MYB0029-02 for 0.5deg | 52mm |